It is always recommended that only a carpenter or a qualified person should install the winding space station unit. Changing stations are equipped with metal and plastic to ensure proper installation and compliance with building codes, stations, changing rooms for children must be properly installed according to manufacturer's instructions.

Baby changing stations can be embedded or surface mounted. Both are safe for babies and children under a certain weight. You can choose which model you have, depending on where you mount it to your home or commercial washrooms. Seat belts are at the station as a security measure for the transport of infants.

Baby Koala Bear Kare ® Changing Stations have been tested to a static load up to 400 pounds. In addition, the device must be properly installed on a wall, capable of supporting that much weight, and the ability to install the hardware provided. The Koala Bear Kare ® Baby Changing rooms Station ADA requirements when properly installed.

Mounting a vertical winding space stations:

1. Remove the station from the shipping container and verify that any damage to transport. Identifying the best position for the installation of the winding space station. Hold the device to open the bed, and make sure there is adequate operating clearance.

2nd Based on the nature of the wall on which is mounted the device, the best method of fitting. Not all hardware can be included for proper installation.

3rd The vertical unit has four mounting holes on the back of 'units, based on a 16 "stud centers. If possible, locate the wood or metal for fastening to wall studs the baby changing rooms in the desired position. If the walls do not have bolts in the middle, like them, make sure that at least part of the device is in such studies. Use the switches (supplied) for holes on the side.

4th Find the stud where they are at the center of the left side of the station on the wall of change. Measure 63 "from floor (59" ADA), in the middle of the stud, and mark the wall. Align the hole in the top left with this label, then use a tape measure and level of the remaining three mounting holes. This research fund Station 31 "from floor (27" ADA).

5th If the wall has wood studs on 16 "centers, drill 1 / 8" pilot holes in the marks and use the four ¼ "x 3" panhead screws with washers supplied. If the wall is masonry or tile over wood studs, use a 7 / 32 "masonry drill until you get to the stud, then proceed to drill 1 / 8" pilot holes into the tunnel and the use of four 1 / 4 "x 3" screws with washers supplied.

For more information, visit these websites http://www.baby-changing-stations.com